2024-03-28T19:22:02Z
https://soar-ir.repo.nii.ac.jp/oai
oai:soar-ir.repo.nii.ac.jp:00013023
2023-03-16T04:43:18Z
1221:1223:1224:1278
極薄板のコニカルカップ試験
Conical Cup Test for Fine Sheet
清野, 次郎
町田, 基
The formability of fine sheets ranging from 0.5 mm to 0.1 mm has recently been discused. So-called conical cup test, developed by Prof. S. Fukui, is also applicable to fine sheet under suitable dimensions of tools and such dimensions for fiine sheets of Al, Cu and Mild Steel are shown. But the above-mentioned test is too difficult for fine and soft sheet, such as alminum of 0.1 mm in thickness, because the centering of the circular blank in the die hole is difficult. In the deep-drawing tests of fine sheets of Al, Cu and Mild Steel by means of the flat punch and conical die, the drawing limit for the conical die of 60 degrees is compared with that for 40 degrees. The result is that the drawing limit in the case of the conical die of 40 degrees is somewhat higher than that obtained for 60 degrees.
Article
信州大学工学部紀要 29: 107-112 (1970)
信州大学工学部
1970-12-25
jpn
departmental bulletin paper
VoR
http://hdl.handle.net/10091/10921
https://soar-ir.repo.nii.ac.jp/records/13023
0037-3818
AN00121228
信州大学工学部紀要
29
107
112
https://soar-ir.repo.nii.ac.jp/record/13023/files/Engineering29-08.pdf
application/pdf
344.9 kB
2015-09-28