2024-03-29T05:37:03Z
https://soar-ir.repo.nii.ac.jp/oai
oai:soar-ir.repo.nii.ac.jp:00013043
2023-03-16T04:42:54Z
1221:1223:1224:1280
内接フェースギヤの研究
Study on Internal Face Gear
両角, 宗晴
One of the principal design problems in the internal face gears is to calculate the face width of the internal face gears. The maximum outside diameter of the internal face gear is limited by the point where the top land of the tooth narrows to a knife-edge, and the minimum inside diameter is limited by the point where the undercut exists in the tooth profile of the internal face gear. In designing the internal face gearsets, the following conditions should be satisfied : (a) The crest of the internal face gear should not be sharpened. (b) The undercut should not exist in the tooth form of the internal face gear. (c) The involute interference should be avoided. (d) The contact ratio should be larger than 1. 0. An analytical study on these subjects mentioned above in the internal face gear is treated by the author, and a pack of the synthetic diagrams available for the design and production of the internal face gearset are prepared. These synthetic diagrams are used for determining the maximum outside diameter, the minimum inside diameter and the face width of the internal face gear. The author shows some numerical examples with a view to facilitating the practical utilization of these diagrams, and the internal face gearsets are made by using the synthetic diagrams presented in this paper.
Article
信州大学工学部紀要 27: 139-156 (1969)
信州大学工学部
1969-12-25
jpn
departmental bulletin paper
VoR
http://hdl.handle.net/10091/11745
https://soar-ir.repo.nii.ac.jp/records/13043
0037-3818
AN00121228
信州大学工学部紀要
27
139
156
https://soar-ir.repo.nii.ac.jp/record/13043/files/Engineering27-09.pdf
application/pdf
1.2 MB
2015-09-28